MAKE ELECTRICAL CONNECTION – U.S.A. ONLY. (EFFECTUER . www. glohi.xsrv.jp o glohi.xsrv.jp Tenga listo Steam models only: Cold water faucet located within 4 ft. washer using the “Y” connector and short hose which are.
Table of contents
- Connect the Water Supply Hose
- Technical Details
- Installing a Washer: It's Easier Than You Think - Self Help and More
- How to Install a Washing Machine
Connect the Water Supply Hose
Then, try the machine again to see if this kinking was causing the problem. If the machine still doesn't drain, you'll have to remove the water pump.
To remove the pump, loosen the bolt that holds the drive belt taut and move the washer motor on the bracket to loosen the belt. Move the motor out of the way and unbolt the pump. As you loosen the last mounting bolt, support the pump with your hand.
Technical Details
Then, lift the pump out of the washer. You should take the pump apart if you can because the trouble could be lint, dirt or pieces of cloth. Clean away all debris inside the pump and clear any debris out of the water tubes. Reassemble and hook up the pump again and test it. If cleaning the pump doesn't put it back into working order, or if the pump housing can't be removed, replace the pump with a new one of the same kind.
- uriah shelton dating history;
- Use the Short Hose as an Extension.
- How to Get Water out of a Whirlpool Cabrio Washer | Home Guides | SF Gate.
- free dating in mk;
To install the new pump, set it into position and connect the mounting bolts to the pump housing. Move the motor back into position. If not, hot should be on the left. Attach the hoses to the faucets--hot to hot and cold to cold. Again, hand tightening should be sufficient.
Installing a Washer: It's Easier Than You Think - Self Help and More
Next, insert the washer's drain hose into the drain pipe yes, it just slides in , and plug the washer in. At this point, slowly turn the faucets on. Check the connections for leakage. For slight leakage, turn off the faucet, tighten the connection slightly with pliers, and turn the faucet back on. Repeat until the connection stops leaking.

Severe leakage indicates a faulty hose or a damaged or missing gasket. Water should run until.
Attach hot water hose to hot water inlet valve marked with a red. Screw coupling by hand until it is snug.
How to Install a Washing Machine
Use pliers to tighten. Repeat with cold water. To reduce risk of hose failure, replace the hoses. Record hose installation or replacement dates for. Turn on water faucets to check for leaks.
A small amount of. It will drain later. Add to my manuals Add. Whirlpool Cabrio Service Manual 60 pages.