Under sink hookup

Diagrams and helpful advice on how kitchen and bathroom sink and drain Slip- joint couplings connect the tailpiece, the main parts of a drain trap, and a short.
Table of contents

Skip to main content. Valve and Faucet Fittings Shut-off valves come with different-sized outlet ports.

How to Hook Up a Copper Pipe to a Sink

References 2 King County: About the Author Chris Deziel has a bachelor's degree in physics and a master's degree in humanities. There was a time when plumbers terminated copper tubing directly on the sink's hot and cold water faucets, but that is no longer done. The under-sink shut-off valves and flex lines makes servicing the sink fixtures easier because the water can be shut off right under the sink.


  • speed dating temple tx.
  • Want FREE Home Tips & Hacks?.
  • .
  • free dating sites in richmond va.

Clean the outside of the copper pipe using the emery cloth. The pipe must be free of all dirt and oxidation for the solder to properly bond to the copper.

Sink & Drain Plumbing

The clean area must extend at least one inch beyond the shut-off valve. Clean the inside of the shut-off vale with the copper fitting brush. Coat the outside of the copper pipe and the inside of the shut-off valve with a liberal coating of the flux paste. Remove the flame and apply the solder to the mating edges of the valve and pipe. A sink drains by way of several components.

A garbage disposal, if there is one, mounts directly to a special strainer body. See How a Garbage Disposal Works.


  1. Your Answer.
  2. kundli matchmaking in hindi.
  3. What Is the Common Waterline Size Under a Sink?.
  4. dating chatting sites free.
  5. How to Hook Up Hot & Cold Water to a Kitchen Sink | Home Guides | SF Gate!
  6. How to Hook Up Hot & Cold Water to a Kitchen Sink.
  7. How to Install a Kitchen Sink Drain (with Pictures) - wikiHow!
  8. For more information, see Bathroom Sink Plumbing. Underneath the sink, a rubber gasket, metal washer, and large locknut or retainer tightens the body to the sink. A straight tailpiece mounts to the strainer body with a threaded coupling. Slip-joint couplings connect the tailpiece, the main parts of a drain trap, and a short threaded nipple at a tee in the drainpipe.